Engine Cooling/Radiator 20 1 2 3 4 Every six months have the coolant mixture checked to ensure it is at the proper concentration to protect the cooling system from damage. Refer to the engine manufacturer’s service literature for specific coolant information. NOTE: Checking the engine coolant level is part of the Pre-trip Inspection. For more information, see the Western Star Driver’s Manual . 1. Park the vehicle on a level surface, set the park- ing brake, and chock the wheels. Open the hood. 2. The level of coolant should be between the FULL and LOW marks in a translucent surge tank (see Fig. 1 and Fig. 3 ) or visible through the sight glass on a steel surge tank (see Fig. 2 ).
If the coolant is low or not visible in the sight glass, check the system for leaks. 05/22/2001 f200643 1. Steel Surge Tank 2. SAE Pressure/Filler Cap 3. Sight Glass 4. Low Coolant Sensor WARNING Do not remove or loosen the radiator cap until the engine and cooling system have completely cooled. Use extreme care when removing the cap. A sudden release of pressure from removing the cap prior to the system cooling can result in a surge of scalding coolant that could cause seri- ous personal injury. Fig. 2, Steel Surge Tank, High Flow Radiators 2 3 3. Slowly turn the SAE pressure/filler cap until it stops, to allow the coolant pressure to bleed off.
Press down on the cap and turn it at the same time, then lift off the cap. 4 4. While the SAE pressure/filler cap is OFF, smell the coolant for strong odors (i.e., diesel fuel). A strong diesel smell indicates that fuel is contami- nating the coolant, and the vehicle must be taken to a Western Star dealer to have the source found and the cooling system chemically flushed. 1 4 5 02/05/2013 f500390 1. Surge Tank Pressure Relief Cap 2. Surge Tank Filler Cap 3. Cold Maximum Coolant Level 4. Cold Minimum Coolant Level 5. Coolant Level Sensor 5. Check the condition of the coolant.
If the coolant shows scale, rust, silica-gel, oil, or has a frothy scum, the vehicle must be taken to a Western Star dealer to have the contaminate source found and fixed, and the cooling system chemi- cally flushed. NOTE: Due to environmental concerns, it is rec- ommended that coolant flushing and the re- placement of coolant conditioners and coolant filters be performed by your Western Star dealer. Fig. 3, Radiator-Mounted Translucent Surge Tank NOTICE Never add cold water into the system when the engine is hot as damage to the engine may result. Western Star Maintenance Manual, September 2015 20/2