Engine Cooling/Radiator 20 20–02 Cooling System Inspection (Noise Emission Control) 1. Park the vehicle on a level surface, set the park- ing brake, and chock the wheels. Open the hood. WARNING Do not remove or loosen the radiator cap until the engine and cooling system have completely cooled. Use extreme care when removing the cap. A sudden release of pressure from removing the cap prior to the system cooling can result in a surge of scalding coolant that could cause seri- ous personal injury. 08/15/94 f200286 A. Screw tip must extend about 1/4 inch (6 mm). B. Washer stack must be compressed almost flat. 1. Adjusting Screw Hex Fig. 4, Breeze Constant-Torque Hose Clamp 6.
If the coolant is low, check the engine oil for pos- sible coolant contamination. If the oil is discol- ored, there may be an internal engine leak, and the unit should be taken to your Western Star dealer to be repaired before the engine is dam- aged. 2. Inspect the SAE pressure/filler cap gaskets. Re- place the cap if the gasket shows any signs of deterioration or damage. Install the cap and check to ensure that it seals properly on the surge tank filler neck. Replace the cap if it ap- pears not to seat properly. 7. Check to see if the front of the radiator, charge air cooler, and oil cooler fins are clogged. Mate- rial in the fins will cause the cooling system to overheat.
Pressure-wash the radiator to wash out radiator clogging material. 3. There is a valve on the bottom of the SAE pressure/filler cap that opens under vacuum. This prevents components in the cooling/heating systems from collapsing. Inspect the vacuum- relief valve to be sure it is not stuck. Replace the cap if the vacuum-relief valve is stuck. 8. Check the fan belts for wear and tightness. For more information on fan belts, see Group 01 . If belts are damaged, replace them. If belts are loose, have the proper belt tension set by your Western Star dealer. 4. Check the hoses for possible leaks. Replace any worn, soft, or perforated hoses. 5.
Western Star uses Breeze Constant-Torque hose clamps on the radiator hoses. Check the hose clamps to ensure that they are properly torqued. See Fig. 4 . The tip of the screw must extend about 1/4 inch (6 mm) from the clamp housing, and the washer stacks must be compressed al- most flat. Hose clamps lose torque after installa- tion due to "compression set." Breeze Constant- Torque hose clamps will hold enough torque to automatically keep consistent sealing pressure. Due to temperature changes, the screw tip ex- tension may change. The clamp screw may need to be adjusted for individual applications. NOTE:
Due to environmental concerns, it is rec- ommended that coolant flushing and the re- placement of coolant conditioners and coolant filters be performed by your Western Star dealer. 9. Check the fan and fan shroud for damage. A damaged fan or shroud will affect the air flow and can cause heating problems. Have the dam- aged fan or shroud replaced by your Western Star dealer. If all the previous steps are correct and the engine is overheating, there may be a problem with the fan not operating properly, or the thermostat may be stuck closed. Take your vehicle to a Western Star dealer to have the problem repaired.
If there is a tendency for the engine to run cool, the fan may be running continously, or the thermostat may be stuck open. Take the vehicle to a Western Star dealer to have the problem repaired. Western Star Maintenance Manual, September 2015 20/3 B A 1 B 1