Daimler Trucks North America LLC Western Star — Western Star

Engine Cooling/Radiator 20 20–03 Pressure/Filler Cap Test 20–04 Cooling System Pressure-Flush WARNING NOTE: See the engine manufacturer’s operation and maintenance manual for cooling system maintenance. The engine manufacturer’s manual is provided with each new vehicle at the time of delivery. Do not remove or loosen the radiator cap until the engine and cooling system have completely cooled. Use extreme care when removing the cap. A sudden release of pressure from removing the cap prior to the system cooling can result in a surge of scalding coolant that could cause seri- ous personal injury. 1. Park the vehicle on a level surface, set the park- ing brake, and chock the wheels.

Open the hood. NOTICE 2. Place a suitable container under the lower elbow of the radiator outlet pipe and under the radiator. The container should be capable of holding 60 quarts (57 L) of fluid. The radiator cap currently installed may not be the same one installed when the vehicle was built. If the radiator cap must be replaced, make sure that it is the correct cap for the cooling system of the vehicle. Because the radiator cap pressure rating affects the operating temperature of the engine, installing an improperly rated radiator cap may have adverse effects on the cooling system, and engine operating temperatures. This could cause premature engine wear or damage.

WARNING Do not remove or loosen the radiator cap until the engine and cooling system have completely cooled. Use extreme care when removing the cap. A sudden release of pressure from removing the cap prior to the system cooling can result in a surge of scalding coolant that could cause seri- ous personal injury. 1. Park the vehicle on a level surface, set the park- ing brake, and chock the wheels. Open the hood. 3. Remove the surge tank pressure/filler cap. 2. After the coolant has cooled, loosen the pressure/filler cap to relieve system pressure. 4. Remove the drain plug located at the elbow of the lower radiator outlet pipe. Allow the coolant to drain. NOTE:

Coolant, conditioners, and coolant filters must be sent to proper recyclers. 3. Remove the pressure/filler cap. Using a radiator- cap pressure tester, check the cap to see if it maintains pressure to within 10 percent of the pressure rating marked on the cap. If it doesn’t, replace the cap. Make sure that the replacement cap is correctly rated for the cooling system of the vehicle. 5. Disconnect the radiator upper and lower hoses. Attach the flushing gun nozzle to the radiator at the lower radiator hose opening. Run the water until the radiator is full. NOTE: When flushing the radiator, do not apply more than 10 psi (103 kPa) air pressure. Exces- sive pressure can damage the radiator. 4.

Inspect the pressure/filler cap gaskets. Replace the cap if the gasket shows any signs of deterio- ration or damage. Install the cap and check that the cap seals properly on the surge tank filler neck. Replace the cap if it appears not to seat properly. 6. Gradually, apply air pressure to help dislodge sediment build up in the radiator core. 5. There is a valve on the bottom of the pressure/filler cap that opens under vacuum. This prevents components in the cooling/heating systems from collapsing. Inspect the vacuum- relief valve to be sure it is not stuck. Replace the cap if the vacuum-relief valve is stuck. IMPORTANT:

All liquid that is flushed out of the radiator must be collected and disposed of prop- erly. Pouring contaminated water down the drain is illegal. 7. Shut off the air at the pressure gun nozzle and allow the radiator to refill with water, then repeat Western Star Maintenance Manual, September 2015 20/4