Clutch 25 4 1 2 3 A 05/24/2011 f250684 A. On vehicles where the pressure line slopes upward, unclamp the hose before bleeding the system; when finished, fasten the hose as removed. 1. Master Cylinder 2. Hydraulic Hose 3. Bracket and P-Clamp Assembly 4. Frontwall Fig. 6, Hydraulic Hose, Upward Slope Installation dure. To order these parts, call Kent-Moore at 1-800-328-6657. 10/25/2011 f250691 1. Park the vehicle on a level surface, shut down the engine, and set the parking brake. Chock the tires and raise the hood. Fig. 5, Reservoir, Hydraulic Clutch Control NOTICE 2. Prepare the pressure bleeding equipment ac- cording to the manufacturer’s instructions.
Use new DOT 4 brake fluid from a tightly sealed con- tainer. Pressurize the bleeder system to 15 psi (103 kPa). Do not spill hydraulic clutch control fluid on the cab paint. Clean it off immediately if any is spilled. Brake fluid can damage paint. 3. Remove the reservoir lid (see Fig. 5 ) and install the pressure bleed adaptor on the reservoir. IMPORTANT: The pressure line must slope con- tinuously downward between the master and slave cylinders. On some vehicles, the securing clamps may need to be removed to achieve this and allow the air to be purged. See Fig. 6 . 4. Bleed the hydraulic system as follows. 4.1 Open the bleed valve on the bleed tank to pressurize the reservoir.
Pressure Bleeding 4.2 Remove the cap from the bleed valve of the slave cylinder. See Fig. 7 . On the valve, install a transparent drain hose connected to a catch bottle. The hose needs to fit the bleed valve tight enough so it does not fall off when fluid is pumped out. NOTE: A bleeder system (J-29532) and a bleed adaptor (J-35798) for the fluid reservoir are available through SPX Kent-Moore Tools and may be used to complete the following proce- Western Star Maintenance Manual, September 2015 25/3