Daimler Trucks North America LLC Western Star — Western Star

Clutch 25 4.3 Open the bleed valve on the slave cylin- der. bottle. The hose needs to fit the bleed valve tight enough so it does not fall off when fluid is pumped out. 4.4 When the draining fluid is clear and free of air bubbles, close the bleed valve. NOTE: The following steps require two people— one in the cab to work the clutch pedal, and one to open and close the bleed valve and watch the fluid. 1 4. Bleed the system, as follows. 4.1 Open the bleed valve. 4.2 Depress the clutch pedal until it stops. 2 4.3 Close the bleed valve. 4.4 Return the pedal to the upper position. 4.5 Repeat the previous steps until the fluid is clear and free of air bubbles.

11/30/2010 f250682 4.6 Depress the clutch pedal. There should be resistance over the full pedal stroke. 1. Bleed Valve 2. Slave Cylinder 5. Check the fluid level in the reservoir. If neces- sary, add or drain fluid to bring the fluid level to between the MIN and MAX lines marked on the side of the reservoir. Install the reservoir lid. Fig. 7, Slave Cylinder, Hydraulic Clutch Control 5. Check the fluid level in the reservoir. If neces- sary, add or drain fluid to bring the fluid level to between the MIN and MAX lines marked on the side of the reservoir. 6. Disconnect the transparent hose. Tighten the bleed valve 88 lbf·in (1000 N·cm) and install the cap on the slave cylinder bleed valve. 6.

Install the reservoir lid. 7. Disconnect the transparent hose. Tighten the bleed screw 88 lbf·in (1000 N·cm) and install the cap on the slave cylinder bleed valve. 25–06 Clutch Replacement, Detroit Automated Transmissions 8. Depress the clutch pedal a few times. There should be resistance over the full pedal stroke. Manual Bleeding Replace the clutch assembly for a Detroit Automated transmission at 750,000-mile (1 200 000-km) inter- vals. Follow the procedure published on the Detroit Diesel Customer Support Network (DDCSN): 1. Park the vehicle on a level surface, shut down the engine, and set the parking brake. Chock the tires and open the hood. NOTE:

The hydraulic system holds approxi- mately 0.5 quart (0.5 liter) of fluid. It may need to be refilled during the bleeding process to pre- vent air from re-entering the system. www.ddcsn.com 2. Remove the reservoir lid and fill the reservoir (see Fig. 5 ) with new DOT 4 brake fluid from a tightly sealed container. 3. Remove the cap from the bleed valve of the slave cylinder. See Fig. 7 . On the valve, install a transparent drain hose connected to a catch Western Star Maintenance Manual, September 2015 25/4