Transmission 26 Safety Precautions 6. Open the hood, and with the engine running at idle, remove the dipstick from the tube and wipe it clean. DANGER 7. Insert the dipstick into the tube completely, then remove the dipstick. When working on the vehicle, shut down the en- gine, set the parking brake, and chock the tires. Before working under the vehicle, always place jack stands under the frame rails to ensure the vehicle can not drop. Failure to follow these steps could result in serious personal injury or death. 8. Check the fluid level mark and repeat the check procedure to verify the reading.
If the fluid level is within the COLD RUN band, the transmission may be operated until the fluid is hot enough to perform a hot check. 26–01 Transmission Fluid Level Inspection If the fluid level is not within the COLD RUN band, add or drain fluid as needed to adjust the fluid level to the middle of the COLD RUN band. See Fig. 1 . Allison Transmission NOTICE B Operating a transmission with the fluid level higher or lower than recommended can result in transmission damage. Do not overfill the transmis- sion. A Do not mix types and brands of fluid, because of possible incompatibility. Do not use fluid addi- tives, friction modifiers, extreme-pressure gear fluids, or multiviscosity lubricants.
Cold Check 12/01/97 f270002a A. Cold Run Band B. Hot Run Band Fig. 1, Dipstick Markings Clean all dirt from around the end of the fluid fill tube before removing the dipstick. Do not allow foreign matter to enter the transmission. Dirt or foreign mat- ter in the hydraulic system may cause undue wear of transmission parts, make valves stick, and clog pas- sages. NOTICE As the fluid temperature increases, so does the fluid level. Do not fill above the COLD RUN band if the transmission fluid is below normal operating temperature. NOTE: Perform a hot check at the first opportu- nity after the normal operating temperature, 160 to 200°F (71 to 93°C), has been reached.
It is important to check the fluid level cold to deter- mine if the transmission has a sufficient amount of fluid to be safely operated until a hot check can be performed. 1. Park the vehicle on a flat, level surface. Hot Check 2. Apply the parking brake and chock the tires. 1. Park the vehicle on a flat, level surface. Apply the parking brake and chock the tires. 3. Run the engine for at least one minute. 2. Shift the transmission to NEUTRAL. 4. Shift from DRIVE to NEUTRAL, and then shift to REVERSE to fill the hydraulic system. 3. Operate the engine at idle (500 to 800 rpm) until normal operating temperature is reached. Check that the sump temperature is 160 to 200°F (71 to 93°C).
Check that the converter-out temperature is 180 to 220°F (82 to 104°C). 5. Shift to NEUTRAL and allow the engine to idle at 500 to 800 rpm. Western Star Maintenance Manual, September 2015 26/1