Transmission 26 4. Open the hood, and with the engine idling, re- move the dipstick from the tube and wipe it clean. 5. Insert the dipstick completely into the tube, and remove the dipstick. 6. Check the fluid level mark and repeat the check procedure to verify the reading. Safe operating level is within the HOT RUN band on the dip- stick. The HOT RUN band is between the HOT FULL and HOT ADD marks. f260006a 05/27/93 A B A. Full B. Low If the fluid level is not within the HOT RUN band, add or drain fluid as needed to bring the fluid level within the HOT RUN band. See Fig. 1 . Fig.
2, Checking Transmission Fluid Level Checking at the Sight Glass Eaton/Fuller Transmission If the transmission is equipped with a sight glass, check the fluid level as follows: 1. Clean the oil level sight glass. See Fig. 3 . NOTICE Operating a transmission with the fluid level higher or lower than recommended can result in transmission damage. Do not overfill the transmis- sion. Overfilling will force fluid out of the case through the main shaft openings. Do not mix types and brands of fluid, because of possible incompatibility. Do not use fluid addi- tives, friction modifiers, extreme-pressure gear fluids, or multiviscosity lubricants.
With the transmission at operating temperature, and the vehicle on a level surface, check the fluid level in the transmission. Some transmissions are equipped with a sight glass for checking the fluid level. For transmissions not so equipped, check the fluid level at the fill plug. Checking at the Fill Plug 1. Clean the area around the fill plug, and remove it from the side of the case. 02/23/2015 f261460 1 2 3 2. Using your finger or a bent pipe cleaner, see if the fluid is level with the fill opening. See Fig. 2 . 1. Drain Plug 2. Fill Plug 3. Sight Glass 3. If the transmission fluid level is low, check the transmission for leaks, and correct as needed. Fig.
3, Eaton Fuller Transmission With a Sight Glass 4. If needed, add the recommended fluid, until it is level with the lower edge of the fill opening. See Table 1 for approved transmission lubricants. 2. Check the fluid level in the sight glass. When the fluid level is at or above 3/4 of the sight glass, then it is at or above the minimum fill level. See Fig. 4 . 5. Clean the fill plug, install it in the transmission, then tighten it 50 lbf·ft (68 N·m). 3. If the fluid level is low, check the transmission for leaks, and correct as needed. Western Star Maintenance Manual, September 2015 26/2