Daimler Trucks North America LLC Western Star — Western Star

Transmission 26 Do not mix types and brands of fluid, because of possible incompatibility. Do not use fluid addi- tives, friction modifiers, extreme-pressure gear fluids, or multiviscosity lubricants. 1. Remove the fill plug from the transmission. 2. Insert a finger or pipe cleaner into the transmis- sion. 02/23/2015 f261461 A B 3. Check that the fluid level is even with the base of the fill plug. A. Full B. Low The correct fluid capacity is established by the fill opening. If the transmission has two fill plugs, check that the fluid level is consistent at both fill plugs. 4. If needed, add the recommended fluid, until it is at or above 3/4 of the sight glass.

See Table 1 for approved transmission lubricants. Fig. 4, Transmission Fluid Level Sight Glass 4. If the transmission fluid level is low, check the transmission for leaks, and correct as needed. Meritor Transmission 5. If needed, add the recommended fluid, until it is level with the lower edge of the fill opening. See Table 1 for approved transmission lubricants. NOTICE Operating a transmission with the fluid level higher or lower than recommended can result in transmission damage. Do not overfill the transmis- sion.

Approved Transmission Lubricants Eaton/Fuller Eaton® Roadranger® Synthetic Transmission Lubricant, or Equivalent All 50W Transmission Make Lubricant Type * Temperature SAE Viscosity Meritor Synthetic Engine Oil meeting Meritor Spec 0–81, MIL SPEC MIL–L–2104D or E All 50W * Do not mix types or brands of fluid. Multi-weight and extreme-pressure gear fluids are not recommended. For a complete list of Eaton approved lubricants, and for more information about Eaton lubricant specifications and suppliers, call 1-800-826-4357 or see www.roadranger.com . Table 1, Approved Transmission Lubricants 6. Clean the fill plug, install it in the transmission, then tighten it 50 lbf·ft (68 N·m). sion.

Overfilling will force fluid out of the case through the main shaft openings. Do not mix types and brands of fluid, because of possible incompatibility. Do not use fluid addi- tives, friction modifiers, extreme-pressure gear fluids, or multiviscosity lubricants. 26–02 Manual Transmission Fluid Change NOTICE NOTE: Fluid change intervals are extended to 500,000 miles (800 000 km) on vehicles equipped with a Meritor RM10–115A or RM10–145A transmission or any vehicle Operating a transmission with the fluid level higher or lower than recommended can result in transmission damage. Do not overfill the transmis- Western Star Maintenance Manual, September 2015 26/3