Transmission 26 equipped with an Eaton/Fuller transmission filled with synthetic transmission fluid. 1. Park the vehicle on level ground, apply the park- ing brakes, and chock the tires. Place a large drain pan under the transmission. To prevent skin burns from hot transmission fluid, wear protective gloves when removing the drain plugs. 4.2 Place a strap or chain wrench around the filter canister, and rotate in a counter- clockwise motion to separate the filter from the mounting. Carefully spin the filter off the mount and remove it. To prevent skin burns from hot transmission fluid, wear protective gloves when removing the drain plugs.
4.3 Apply a light coat of transmission fluid to the O-ring gasket on the new filter. Fill the filter with the specified transmission fluid, and spin the filter on the mount. 2. Clean the area around the fill plug, and remove it from the side of the case. Remove each drain plug from the bottom of the transmission case. Drain the fluid while the transmission is warm. 3. Clean the fill and drain plugs. NOTE: The filter fills slowly, so be patient to ensure the proper fluid level has been reached. For magnetic plugs, use a piece of key stock or any other convenient steel slug to short the two magnetic poles and divert the magnetic field. Clean the material that may have been attracted to the magnet.
The amount of material on the magnetic plug shows the condition and wear in the transmission; excessive material may indi- cate that the transmission should be looked at. Remove the key stock or steel slug from the magnetic drain plug. 4.4 Once the filter has made contact with the mount, use a strap or chain wrench to rotate the filter canister an additional 180 to 270 degrees to firmly tighten the filter. Wipe the filter clean of any fluid after it is tightened. 5. Add fluid until it is level with the lower edge of the fill opening. See Fig. 1 . If the transmission has two fill openings, add fluid to the level of both openings.
See Table 1 for approved trans- mission lubricants, and Table 2 for lubricant ca- pacities. The correct capacity is established by the location of the fill opening. Install and tighten each drain plug 50 lbf·ft (68 N·m). NOTE: Eaton/Fuller transmissions are available with an optional transmission fluid filter. The fil- ter is a remote-mount, spin-on type, and is lo- cated between the transmission and the fluid cooler. The filter bracket is attached to the frame rail. The filter is mounted in a vertical position, and should be filled with fluid before installation to ensure the proper fluid level in the transmis- sion case.
For optimum transmission perfor- mance, change the filter each time the fluid is changed. 6. For a transmission equipped with a fluid pump or a fluid cooler, operate the engine for five minutes after filling the transmission, then check the fluid level again. 7. Install the fill plug, then tighten it 50 lbf·ft (68 N·m). 8. Operate the vehicle to check for correct opera- tion. 4. For an Eaton/Fuller transmission with a transmis- sion fluid filter(s), replace the filter(s), as follows. Transmission Lubricant Capacities 4.1 Place a drain pan under the transmission fluid filter. Transmission Make and Model * Capacity:
pt (L) T–14607A/B 37 (17.5) Eaton/Fuller 7-Speed TX–14607B 37 (17.5) Eaton/Fuller 9-Speed Western Star Maintenance Manual, September 2015 26/4 CAUTION CAUTION