Transmission 26 6. Install the small O-ring in the end cap, then in- stall the end cap and tighten it 8 to 12 lbf·ft (11 to 16 N·m). 26–05 Transmission Inspection Check the transmission for oil leaks, as follows. NOTICE 1. Check at the transmission output shaft for oil leaks. A small amount of oil and dirt accumula- tion is normal, as a small amount of oil is al- lowed past the seal to lubricate it. If the rear of the transmission is wet with oil, the rear seal may need replacing. A leaking air filter or air lines can cause slow or hard shifting of the transmission, and eventual transmission damage. 7. Start the engine, and build pressure in the air system.
Check for air leaks at the filter housing and air line connections; repair any leaks. Meritor 2. Check for oil leaks around the speedometer pickup. 3. Check the transmission case joints for oil leaks. 4. Check transmission oil line fittings for oil leaks. 1. Park the vehicle on a level surface. Apply the parking brakes and chock the tires. 5. Check the bottom of the flywheel housing for oil accumulation. Oil along the bottom seam or around the inspection cover of the flywheel hous- ing may be an indication of a transmission input seal leak. Not replacing a leaking input oil seal will cause clutch slippage. 2. Remove the element from the air filter/regulator assembly.
Inspect the O-rings in the end cap; replace worn or damaged O-rings. Inspect the element for fluid contamination. If fluid is present, replace the element. Inspect the air supply sys- tem for the source of the fluid, and service it as needed. 6. If leaks are found, take the vehicle to your West- ern Star dealer to have the problem corrected. 3. Install the element in the filter/regulator assem- bly. 26–06 Allison and Eaton Fuller Transmission Breather Check 4. Apply a light coat of silicone grease, or an equivalent grease to the O-rings in the end cap. Install and tighten the end cap 10 to 15 lbf·ft (14 to 20 N·m). If the transmission is equipped with a housing breather (see Fig.
7 ), it must remain clear. A plugged breather could result in pressure build-up, which could cause oil leakage. 5. Build air pressure in the system, check for leaks, and make any needed repairs. IMPORTANT: Do not spray water, steam, or cleaning solution directly at the breather. These actions can force water or cleaning solution into the transmission and contaminate the transmis- sion fluid. 26–04 ESS Transmission Filter and Boot Inspection On ESS transmissions only, inspect the filter and protective boots. 1. Remove the filter from its location on the top right-hand side of the transmission. If the breather is plugged, clean or replace it.
If re- placing it, use a correct-size wrench (pliers or a pipe wrench can crush or damage the breather stem and produce metal particles that could enter the transmis- sion). 2. Clean the filter with solvent. 3. Install the filter, as removed. 4. Inspect the protective boots, both right and left, for tears or signs of cracking. Replace if needed. Check more often if the vehicle is operating under very dusty conditions. Western Star Maintenance Manual, September 2015 26/7