Transmission 26 have been used for water or antifreeze. Dirt, water, or antifreeze could damage the transmission. 2 Engine coolant in the transmission hydraulic sys- tem requires immediate action to prevent malfunc- tion and possible serious transmission damage. For more information, see the Allison Transmis- sion website, www.allisontransmission.com . 1 IMPORTANT: When draining transmission fluid, check for evidence of dirt or water contamina- tion. A small amount of condensation could ap- pear in the fluid during operation. Water contamination is normally characterized as a milky discoloration of the transmission fluid.
Obvious contamination of the transmission fluid could indicate a leak between the water and fluid areas of the transmission cooler. Inspect and pressure-test the cooler to confirm the leak. If the transmission cooler is leaking and the oil has been contaminated, replace the transmis- sion cooler and overhaul the transmission. f260007b 11/30/2010 NOTE: Location of the transmission breather will vary depending on transmission model. 1. Breather 2. Shift Tower Fig. 7, Transmission Breather (Eaton Fuller shown) 26–07 Allison Transmission Fluid and Filter Change NOTE: If only the filters are being changed, do not drain the fluid. 3. Clean the area around the drain plug and the transmission fluid pan.
Place a drain pan under the transmission and remove the drain plug. Ex- amine the fluid as it drains. Allison 3000 Family and 4000 Family Transmissions NOTE: When the optional prognostics feature is enabled on an Allison transmission, the system monitors oil life and filter life. To reset the indica- tor, press the Mode button (on the electronic shift control) for 10 seconds with the ignition on but the engine not running. For more informa- tion, see the Allison Transmission website, www.allisontransmission.com . 4. Remove the 12 mounting capscrews (six each) from the two filter covers. See Fig. 8 . NOTE: A lot of fluid will drain when the filter covers are removed. 5.
Remove the filter covers, gaskets, O-rings, and filters from the transmission. 6. Lubricate the new O-rings with transmission fluid, and install them on the covers. 1. Park the vehicle on a level surface and apply the parking brakes. 7. Install the filter over the gaskets. 2. Operate the vehicle until the transmission reaches normal operating temperature: 160 to 200°F (71 to 93°C). 8. Install the fluid filters on the cover assemblies. 9. Install the filter and cover assemblies into the filter compartment. Align each cover assembly with the holes in the channel plate sump, and push the cover assemblies in by hand to seat the seals.
NOTICE To prevent dirt from entering the transmission, use only clean containers and fillers for the trans- mission fluid. Do not use fillers or containers that Western Star Maintenance Manual, September 2015 26/8