Transmission 26 NOTICE Do not use the capscrews to draw the filter covers to the sump. This can damage the covers, seals, or sump. 2 10. Install six capscrews in each cover, and torque the bolts 38 to 44 lbf·ft (51 to 61 N·m). 2 11. Install a new drain plug O-ring, and install the drain plug. Tighten the drain plug 18 to 24 lbf·ft (25 to 32 N·m). NOTE: Fluids meeting specification TES 295 are preferred over TES 389 fluids for use in Allison 3000 and 4000 family transmissions. See the Allison Transmission website ( www.allison- transmission.com ) for a list of approved trans- mission fluids and usage recommendations. 12. Refill the transmission with fresh transmission fluid.
Use only a fluid that meets Allison Trans- mission specification TES 295 or TES 389. Cas- trol TranSynd® is a TES 295 fluid available through Allison distributors and dealerships. See Table 3 for lubricant refill capacities. 7 6 6 Lubricant Refill Capacities, Allison 3000 and 4000 Family Transmissions * 5 5 4 4 Family Sump Size Capacity : qt (L) 3000 4 Inch 19 (18) 3 3 2 Inch 17 (16) 4000 4 Inch 39 (37) 1 1 2 2 * Quantities listed are approximate. Add listed amount of fluid, then perform a "hot check" and add fluid as needed. Do not overfill. Add 3 qt (2.8 L) for transmissions with PTO.
Table 3, Lubricant Refill Capacities, Allison 3000 and 4000 Family Transmissions 2 Inch 31 (30) f261435 09/12/2011 NOTE: Allison 4000 Family transmission shown. Com- ponents and location are similar for Allison 3000 Family transmissions. 13. Check and adjust the fluid level using the appro- priate Allison Transmission procedures in MOP 26–01 . 1. Capscrew 2. Filter Cover 3. Gasket 4. O-Ring 5. Filter Element O-Ring 6. Filter Element 7. Drain Plug Fig. 8, Allison Transmission Filter Locations and Components Western Star Maintenance Manual, September 2015 26/9