Daimler Trucks North America LLC Western Star — Western Star

Transmission 26 26–08 Detroit Automated Transmission Fluid Change and Magnetic Plug Cleaning 2 NOTICE Operating a transmission with the fluid level higher or lower than recommended can result in transmission damage. Do not overfill the transmis- sion. Overfilling will force fluid out of the case through the main shaft openings. 1 Do not mix types or brands of fluid, because of possible incompatibility. Do not use fluid addi- tives, friction modifiers, or extreme-pressure gear fluids. 03/31/2014 f270167 1. Drain Plug 2. Fill Plug Fig. 9, Drain and Fill Plugs, Detroit Automated Transmissions IMPORTANT: Drain the transmission when the fluid is warm.

If not already warm, run the en- gine until the transmission fluid reaches operat- ing temperature. Shift the transmission to neu- tral (N) and shut down the engine. 1. Apply the parking brakes, and chock the rear tires. Place a large drain pan under the transmis- sion. 1 2 2. Clean the area around the fill plug, then remove it from the side of the gear case. Remove the drain plug from the bottom of the case. See Fig. 9 . 3 4 3. Clean the fill plug and the drain plug. 4. Remove the oil pump screen and check it for debris. See Fig. 10 . Clean the screen, if needed, then install it with a new seal washer. Tighten the plug 90 lbf·ft (120 N·m). 02/21/2014 f261459 1. Spring 2. Screen 3.

Seal Washer 4. Plug 5. Install a new seal on the drain plug, then install the plug and tighten it 45 lbf·ft (60 N·m). Fig. 10, Oil Pump Screen, Detroit Automated Transmissions NOTICE 6. Add fluid until it is level with the lower edge of the fill opening; see Fig. 11 . See Table 4 for ap- proved transmission lubricants, and Table 5 for transmission lubricant capacities. NOTE: In all cases, the correct fluid level is es- tablished by checking at the fill opening. Detroit transmissions use synthetic lubricant that meets the requirements of the MB 235.11 specifi- cation, such as Detroit Synth 75W-90.

Using lubri- cant that does not comply with this specification will result in damage to the transmission. The oil part number can be found in module 348 in PartsPro. 7. Operate the engine for five minutes after filling the transmission, then check the fluid level again. Western Star Maintenance Manual, September 2015 26/10