Daimler Trucks North America LLC Western Star — Western Star

Transmission 26 8. Install a new seal on the fill plug, then install the plug and tighten it 45 lbf·ft (60 N·m). Do not mix types or brands of fluid, because of possible incompatibility. Do not use fluid addi- tives, friction modifiers, or extreme-pressure gear fluids. 9. Operate the vehicle to check for correct operation. With the transmission at operating temperature, and the vehicle on a level surface, check the fluid level in the transmission. 1. Clean the area around the fill plug, then remove it from the side of the gear case. 2. Using your finger or a bent pipe cleaner, see if the fluid is level with the fill opening. See Fig. 11 . f260006c 11/30/2010 A B 3.

If the fluid level is low, check the transmission for leaks, and correct as needed. A. Full B. Low Fig. 11, Checking Transmission Fluid Level NOTICE Detroit Transmission Lubricants Detroit transmissions use synthetic lubricant that meets the requirements of the MB 235.11 specifi- cation, such as Detroit Synth 75W-90. Using lubri- cant that does not comply with this specification will result in damage to the transmission. The oil part number can be found in module 348 in PartsPro. Specification Example MB 235.11 Detroit Synth 75W-90 Table 4, Detroit Transmission Lubricants Detroit Transmission Lubricant Capacities 4.

If needed, add the recommended fluid until it is level with the lower edge of the fill opening. See Table 4 for approved transmission lubricants. Small 10.7 (10.1) Transmission Size Refill Capacity * : qt (L) Large 15.4 (14.6) 5. Clean the fill plug and install a new seal on it. Install the plug in the side of the gear case, then tighten it 45 lbf·ft (60 N·m). NOTE: Transmission size is represented by the sixth digit of the model name. An "A" indicates a large transmission, and "B" indicates a small transmission. For example, a DT12-DA-1550 is a large transmission. 26–10 Detroit Automated Transmission Air Filter Replacement * Quantities listed are approximate.

Fill transmission until lubricant is level with bottom of fill hole with vehicle in normal operating position. Table 5, Detroit Transmission Lubricant Capacities 26–09 Detroit Automated Transmission Fluid Level Inspection NOTE: The information in this MOP only applies if the vehicle is equipped with a transmission air filter. 1. Park the vehicle on a level surface, shut down the engine, and set the parking brake. Chock the tires. NOTICE 2. Drain the main air system and the isolated trans- mission reserve air tank. See Fig. 12 . Operating a transmission with the fluid level higher or lower than recommended can result in transmission damage. Do not overfill the transmis- sion.

Overfilling will force fluid out of the case through the main shaft openings. 3. Remove the air filter canister, located between the main air system and the transmission reserve air tank. See Fig. 13 . Western Star Maintenance Manual, September 2015 26/11