Daimler Trucks North America LLC Western Star — Western Star

Frame and Frame Components 31 1 A 2 04/11/2011 f310887 B A. The nut and washer should be snug against the fifth wheel. B. The locks should be completely closed around the kingpin. 04/11/2011 f310470 1. Operating Handle 2. Lever Bar Fig. 6, Lever Bar and Operating Handle Alignment Fig. 4, Holland Fifth Wheel Properly Closed 6. Check all cotter pins for cracking or damage. Re- place any cotter pin that shows any signs of damage. 4. When the wheel is locked, the safety latch must swing free and fall freely into position. See Fig. 5 . 7. Level the fifth wheel plate to a horizontal posi- tion. Measure the height from a stationary mounting point (see Fig.

7 , item 3), such as the frame rail to the top of the fifth wheel plate (item 1). Pry up on the fifth wheel plate (item 4) below the pin boss, and measure the vertical move- ment (item 5). The bracket connection provides a 9/32 inch (7 mm) vertical clearance to provide cushioning and to avoid downward pin-loading while retaining minimum plate lift. If the plate lift (Ref. A) exceeds 5/16 inch (8 mm) as a result of wear or rubber deterioration, install new bracket- shoe rubber pads. NOTE: Do not measure plate lift immediately after a trailer has been uncoupled from the fifth wheel.

The rubber may have taken a temporary set, which will normally recover after being un- coupled for a short period of time. 1 2 3 4 10/26/2010 1. Lubricant Grooves 2. Safety Latch 3. Lock Control Handle 4. Mount f310353b Fig. 5, Simplex Series Fifth Wheel 8. Check all mounting bolts for signs of fatigue, and tighten them to the proper torque. For torque specifications, see Group 00 . Inspect all angles, plates, and brackets for cracks or other damage. 5. The lever bar and operating handle must be in proper alignment. See Fig. 6 . Compare the lever bar and operating handle alignment to a new, or a properly operating lever bar and operating handle.

Replace any bent or misaligned lever bar or operating rod. 9. Replace cracked, worn, or damaged parts with new parts. Replace all loose mounting bolts with 5/8–11 Grade 8 bolts, Grade C locknuts, and Western Star Maintenance Manual, September 2015 31/4