Frame and Frame Components 31 A 5 1 2 09/01/2009 f311101 f310475 04/11/2011 A. Extended Top Plate Lift Height 1. Fifth Wheel Top Plate 2. Fifth Wheel Frame Mount 3. Frame Rail 4. Lifting Point 5. Static Top Plate Height Fig. 8, Bracket Pin Bolt Locking Tabs 7. Check the fifth wheel adjustment. Using a lock tester, lock and unlock the fifth wheel several times. Make sure that the locking mechanism works properly. The lock is properly adjusted if: the wheel locks and unlocks easily each time and the lock tester rotates freely. Fig. 7, Measuring Fifth Wheel Top Plate Lift hardened washers. Do not re-use bolts, nuts, and washers on fifth wheel mountings. The lock is too loose if:
you feel fore-aft play when pulling and pushing on the lock tester handle. See Fig. 9 , Ref. A. 10. After inspecting the fifth wheel, lubricate all mov- ing parts with a chassis or multipurpose grease. See Maintenance Operation 31–02 for lubrica- tion instructions. The lock is too tight if: the lock tester does not rotate freely in the lock. See Fig. 9 , Ref. B. 8. If the lock is improperly adjusted, correct as fol- lows. Jost 1. Disconnect the tractor from the trailer. For in- structions, see the Western Star Driver’s Manual . If the lock is too tight, loosen the jam nut, turn the adjustment bolt clockwise one full turn, then reset the jam nut.
Lock and unlock the mecha- nism several times to test. Repeat if necessary. See Fig. 10 . 2. Thoroughly steam clean the fifth wheel. 3. Check the mounting for missing or damaged fas- teners, and broken components. Replace or re- pair as needed. If the lock is too loose, loosen the jam nut, turn the adjustment bolt counterclockwise one full turn, then reset the jam nut. Lock and unlock the mechanism several times to test. Repeat if nec- essary. See Fig. 10 . 4. Inspect the bracket pin bolts. Make sure the lock- ing tabs are properly securing the bolts in place. See Fig. 8 . 5. Check the fifth wheel for bent, worn, or broken parts. Replace as needed. 9.
If the fifth wheel is equipped with a sliding mechanism, inspect and adjust it as follows. 6. If the fifth wheel is equipped with low-lube plates, check the plates and replace if damaged or worn down to the securing bolts. It is normal for out- side edges of the plate to pucker slightly; this does not affect performance. 9.1 Check the bracket for any cracks or miss- ing and damaged parts. 9.2 Inspect the locking plungers for full en- gagement. 9.3 Check the locking mechanism for proper operation. Western Star Maintenance Manual, September 2015 31/5 3 4