Daimler Trucks North America LLC Western Star — Western Star

Frame and Frame Components 31 plate to fill the grooves, or depressions, on the top plate. See MOP 31–02 for lubrication instruc- tions. NOTE: Do not use a lube plate (high density polyethylene) on top of the fifth wheel or on the kingpin instead of grease without prior approval by Fontaine Fifth Wheel. The additional thick- ness of this material can prevent the proper op- eration of the fifth wheel and may cause a dan- gerous condition. 31–02 Fifth Wheel Lubrication To maintain proper fifth wheel operation, always lubri- cate the fifth wheel after an inspection has been performed. NOTE:

Fontaine suggests the use of a Moly based lubricant such as Mobilgrease XHP 320 or equivalent when applying lubricant to the locking jaw and wedge. IMPORTANT: Lubricate the fifth wheel: After power washing or steam cleaning. If the vehicle operates in harsh conditions such as salt spray from road surfaces, or in ex- tremely dusty environments. 3. Lubricate the fifth wheel prior to opening and closing it. Separate the jaw and wedge with a screwdriver, and grease the full length of their mating surfaces. Lubricate the top and bottom contact surfaces of the jaw and wedge. See Fig. 1 . Open and close the fifth wheel several times to further distribute the grease.

After any service that requires removal of lubri- cation from the fifth wheel head or components. WARNING Lightly oil other moving parts in the fifth wheel. Failure to properly lubricate the fifth wheel could result in a possible disengagement of the trailer from the tractor, which could result in personal injury or property damage. Fontaine 4. Apply grease to the top plate. Spread grease all over the mating surface of the top plate. Be sure the grease pockets built into the top plates are full of grease. Holland FWS1 1.

Tilt the top plate forward (the front of the fifth wheel is down) and apply grease to each bearing area through the zerk fittings located on each side of the top plate just to the front of the bracket pins. Continue to apply grease until it is coming out of the back of the bearing. It may be necessary to raise the rear of the fifth wheel with a pry bar to open up the pocket slightly and allow the grease to flow through. A substantial amount of grease may be required initially to fill the reservoir. Apply a heavy coat of grease to the top plate, either through the grease fittings located on the underside of the top plate, or by direct application. Holland FW35 1.

Using a water-resistant lithium-base grease, grease the top plate. 2. Using a light oil (such as SAE 10W or 20W motor oil), lubricate the cam track and pivot. See Fig. 11 . Tilt the fifth wheel ramps down (the rear of the fifth wheel is down) and repeat the greasing pro- cedure. Rock the top plate back and forth sev- eral times to spread the grease over the bearing surface. 3. Grease the yoke tips, locks, and the release handle and spring; see Fig. 12 . Grease the mounting bracket supports through the grease fittings. A “low temp” grade grease rated for -30°F (-34°C) or lower such as Cato Oil and Grease #5213, Craftsman Chemical Co. #LTF 2, Mystic LP-200, or equivalent is recommended.

Castloc II and Simplex Series 2. Inspect the trailer kingpin plate and top surface of the fifth wheel to make sure each is properly greased. A liberal coating of grease should be applied to the complete surfaces of both the trailer kingpin plate and the top surface of the fifth wheel. Use a chassis or multipurpose grease to lubricate the two grease fittings located on either side of the fifth Western Star Maintenance Manual, September 2015 31/7