Suspension 32 Rear Suspension Freightliner Single Axle the bushings and pins to allow the proper flow of lubricant around them. 3. Use a multipurpose chassis grease, and lubricate the bronze, ball-indented bushings in the spring eyes at the grease fitting. See Fig. 10 . Continue to lubricate until grease exits both ends of the bushing. If the pin will not accept lubricant, re- move the pin and clean the lubrication channels where lubricant may have hardened. No lubrication is required on a Freightliner single-axle rear suspension.
Tandem Axle Lubricate the equalizer cap-and-tube assembly bush- ings by applying multipurpose chassis grease at the grease fitting until the old grease is forced out from the cap-and-tube assembly. See Fig. 9 . 4 2 3 1 A 2 4 1 320020a 05/27/93 1 09/15/95 f320424 1. Bronze Bushing 2. Lubrication Hole 3. Grease Fitting 4. Lubrication Groove A. Lubricate here. 1. Cap-and-Tube Assembly Bushing Fig. 10, Hendrickson RT2 and RTE2 Series Bushing Lubrication Chalmers Fig. 9, Equalizer Assembly Lubrication Neway No lubrication is required on a Chalmers rear sus- pension. Hendrickson No lubrication is required on a Neway rear suspen- sion.
Reyco The Hendrickson RS Series suspension does not require lubrication. No lubrication is required on a Reyco rear suspen- sion. For Hendrickson RT2 and RTE2 Series, lubricate the bronze, ball-indented bushings in the spring eye, as follows. 32–03 Suspension U-Bolt Torque Check 1. Park the vehicle on a level surface, apply the parking brakes, and chock the front tires. 2. Raise the rear of the vehicle until the rear wheels are suspended in the air, then support the ve- hicle with safety stands. This relieves the load on Failure to retorque the U-bolt nuts could result in spring breakage and abnormal tire wear. Western Star Maintenance Manual, September 2015 32/9 CAUTION