Daimler Trucks North America LLC Western Star — Western Star

Suspension 32 WARNING WARNING Be sure that the fasteners are torqued correctly. Fasteners that are not tight can cause separation of components or premature failure of compo- nents, loss of vehicle control and possible per- sonal injury or property damage. Be sure that the fasteners are torqued correctly. Fasteners that are not tight can cause separation of components or premature failure of compo- nents, loss of vehicle control and possible per- sonal injury or property damage. 2. Visually inspect each suspension bracket for any evidence of cracks and rust streaks coming out from between the frame rail and the bracket. 2. Check the torque of the suspension U-bolts.

For instructions, see Maintenance Operation 32-03 , "Suspension U-Bolt Torque Check." 3. Check the shock absorbers. For instructions, see Maintenance Operation 32-01 , "Suspension In- spection." 3. Check the shock absorbers. For instructions, see Maintenance Operation 32-01 , "Suspension In- spection." 4. Inspect the air bags for sufficient and equal pres- sure. Examine the air bags for wear and cuts. 4. Inspect the leaf springs for worn or broken spring leaves.

WARNING WARNING If damaged air bags are found, do not continue to use the vehicle, take the vehicle to your Western Star dealer to have the air bags replaced because the sudden loss of air bag pressure can cause loss of vehicle control resulting in serious per- sonal injury and property damage. Do not replace individual leaves of a damaged leaf spring assembly; replace the complete spring as- sembly. Visible damage (cracks or breaks) to one leaf causes hidden damage to other leaves. Re- placement of only the visibly damaged part(s) is no assurance that the spring is safe. On front spring assemblies, if cracks or breaks exist in the two top leaves, a loss of vehicle control could occur.

Failure to replace a damaged spring assem- bly could cause an accident resulting in property damage, serious personal injury, or death. 5. Park the vehicle on a level surface, using a light application of the brakes. Do not apply the park- ing brakes. Shift the transmission into neutral, and build the secondary air pressure to at least 100 psi (690 kPa). Shut down the engine. 5. Inspect each frame hanger for any evidence of cracks and rust streaks coming out from between the frame rail and the bracket. 6. Mark the location of the front and rear tires on the floor, and chock the tires on one axle only. 7.

Check the ride height by measuring the distance from the bottom of the frame rail to the center of the axle. The correct ride height is from 9-3/4 to 10-1/4 inches (248 to 260 mm). Reyco Suspension 32–02 Suspension Lubrication Front Suspension Weekly, grease the front spring pins and rear shackle pins. Wipe all dirt away from grease fittings (if equipped) on the spring-eye bushings. Apply multi- purpose extreme pressure (EP) chassis grease with a pressurized grease gun until old grease is forced out. For some applications, like twin steer, the grease fitting is toward the inside, for clearance. When greasing the spring pins, always raise the vehicle to remove vehicle weight from the springs.

WARNING Before making any inspections, always make sure that the vehicle’s park brake is set and that the wheels are chocked to prevent accidental vehicle movement to prevent serious injury. 1. Inspect the fasteners that attach the suspension brackets to the frame for proper torque. See Group 00 for bolt torque specifications. Western Star Maintenance Manual, September 2015 32/8