Suspension 32 WARNING 3. Visually inspect each suspension bracket for any evidence of cracks and rust streaks coming out from between the frame rail and the bracket. Do not replace individual leaves of a damaged leaf spring assembly; replace the complete spring as- sembly. Visible damage (cracks or breaks) to one leaf causes hidden damage to other leaves. Re- placement of only the visibly damaged part(s) is no assurance that the spring is safe. On front spring assemblies, if cracks or breaks exist in the two top leaves, a loss of vehicle control could occur. Failure to replace a damaged spring assem- bly could cause an accident resulting in property damage, serious personal injury, or death.
4. Check shock absorbers every 18,000 miles (30,000 kilometers). For instructions, see Mainte- nance Operation 32-01 , "Suspension Inspec- tion." 5. Inspect the air bags for sufficient and equal pres- sure. Examine the air bags for wear and cuts. WARNING If damaged air bags are found, do not continue to use the vehicle, take the vehicle to your Western Star dealer to have the air bags replaced because the sudden loss of air bag pressure can cause loss of vehicle control resulting in serious per- sonal injury and property damage. 4. Inspect the cam surfaces of the number two spring bracket and number three spring bracket for wear due to high mileage. See Fig. 8 .
Also check the inner side edges of the hanger legs for wear. Excessive wear on the sides of the legs is an indicator there my be problems with the spring eye bushing. Excessive wear at either point requires that the spring hanger be re- placed. 6. Park the vehicle on a level surface, using a light application of the brakes. Do not apply the park- ing brakes. Shift the transmission into neutral, and build the secondary air pressure to at least 100 psi (690 kPa). Shut down the engine. 5. Check the shock absorbers. For instructions, see Maintenance Operation 32-01 , "Suspension Inspection." Hendrickson HAS 7.
Mark the location of the front and rear tires on the floor, and chock the tires on one axle only. 8. Check the ride height by measuring, directly above the axle, the distance from the bottom of the frame rail to the bottom of the main support member. The correct ride height is 4-1/4 inches (108 mm). WARNING Before making any inspections, always make sure that the vehicle’s park brake is set and that the wheels are chocked to prevent accidental vehicle movement to prevent serious injury. If any problem is found, take the vehicle to your Western Star dealer to have the problem corrected. Neway Suspension 1.
Inspect the fasteners that attach the suspension brackets to the frame for proper torque. See Group 00 for bolt torque specifications. WARNING WARNING Before making any inspections, always make sure that the vehicle’s park brake is set and that the wheels are chocked to prevent accidental vehicle movement to prevent serious injury. Be sure that the fasteners are torqued correctly. Fasteners that are not tight can cause separation of components or premature failure of compo- nents, loss of vehicle control and possible per- sonal injury or property damage. 1. Inspect the fasteners that attach the suspension brackets to the frame for proper torque. See Group 00 for bolt torque specifications. 2.
Check the torque of the suspension U-bolts every 24,000 miles (40,000 kilometers). For in- structions, see Maintenance Operation 32-03 , "Suspension U-Bolt Torque Check." Western Star Maintenance Manual, September 2015 32/7