4M41 ENGINE - Crank Shaft and Crank Case 11B-25-8 4. CYLINDER BORING (1) Determine the oversize piston to be used based on the largest cylinder inside diameter. (2) There are two types of oversize pistons available (+0.50 mm and +1.00 mm). Bore the cylinders so that the clearance between the cylinder and the piston installed meets the specified standard value. The reference point for piston O.D. measurement is as shown. 53.5 mm C Standard value: 0.04 - 0.05 mm (3) Based on the measured piston outside diameter, calculate the necessary boring dimension as follows. D Boring dimension = Piston O.D.
+ 0.04 to 0.05 mm (piston-to-cylinder clearance) - 0.05 mm (honing allowance) (4) Grind each cylinder to the calculated boring dimension. Caution 1. Because of the hardened cylinder layer, the use of a BORAZON TIP is recommended. 2. To avoid thermal distortion, bore the cylinders in the order of No. 2, No. 4, No. 1 and No. 3. (5) Hone each cylinder to the final bore (piston O.D. + piston-to-cylinder clearance). NOTE (1) Honed surface roughness: 2 to 4 m m (2) Honing crosshatch angle: 15 to 25 _ (half angle) (3) Cylinder bore out-of-squareness: 0.05 mm (6) Check that the piston-to-cylinder clearance is within the specified standard value range. Standard value: 0.04 - 0.05 mm PWEE9409-D E Feb.
2000 Mitsubishi Motors Corporation Added