4M41 ENGINE - Crank Shaft and Crank Case 11B-25-7 22 (2) Bend 1) To measure the bend of the crankshaft 22 , support it at No. 1 journal C and No. 5 journal D and read the runout at No. 3 journal E . 2) If the reading exceeds the specified service limit, replace the crankshaft 22 . C E D Standard value: 0.02 mm or less Limit: 0.05 mm NOTE The bend of the crankshaft 22 is a half of the dial gauge reading obtained when the crankshaft is rotated one turn. A 3. UPPER CRANKCASE (1) Top Surface Distortion If the reading exceeds the specified limit, eliminate distortion using a surface grinder. A : Measuring direction Standard value: 0.05 mm or less Limit:
0.1 mm Caution The surface grinding of the upper crankcase 29 should be limited to such an extent that piston protrusions do not deviate from specified standard value. Cylinder (2) Cylinder Inside Diameter If the cylinder inside diameter exceeds the specified limit, bore the cylinder to the next oversize. 20 mm A B 80 mm Standard value: 98.5 - 98.53 mm Limit: 98.75 mm 130 mm A : Measuring direction in cylinder (axial direction of crankshaft) B : Measuring direction in cylinder (right angled to crankshaft) C : Measuring direction on piston (right angled to piston pin hole) Caution 1. If any of the cylinders exceeds the limit, bore all the cylinders to the next oversize. 2.
Irrespective of the cylinder I.D. being within the specified limit, replace the piston and piston rings if the cylinder-to-piston clearance deviates from the standard value. 53.5 mm C PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added