Mitsubishi — 25. CRANK SHAFT AND CRANK CASE

4M41 ENGINE - Crank Shaft and Crank Case 11B-25-6 INSPECTION 1. MAIN BEARINGS Caution 1. Be sure not to use the main bearings 16 and 25 expanded forcedly. 2. When either the main bearing 16 or 25 is defective, replace them in pairs. (1) Free Span If the reading for either main bearing shell 16 , 25 exceeds the specified service limit, replace them in pairs. Limit: Less than 73.16 mm 16, 25 25 (2) Main Bearing-to-Crankshaft Clearance 1) Fit the upper main bearing shells 25 and lower main bearing shells 16 into the upper crankcase 29 and lower crankcase 17 respectively, then tighten main cap bolts 14 to a torque of 20 ± 2 Nm. 2) Measure the I.D.

of the main bearings 16 , 25 and the journal O.D. at M of the crankshaft 22 . If the measurements exceed the specified limits, replace the defective part(s). 29 17 16 14 Standard value: No. 1, 2, 4, 5 journal 0.04 - 0.06 mm No. 3 journal 0.06 - 0.08 mm 22 M Limit: 0.1 mm 22 B A 2. CRANKSHAFT (1) Out-of-Roundness and Conicity of Crankshaft Journal and Pin If the measured value exceeds the limit, replace the crankshaft 22 . A : Out-of-Roundness B : Conicity Standard value: Out-of-Roundness 0.01 mm or less Conicity 0.006 mm or less PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added