Mitsubishi — 25. CRANK SHAFT AND CRANK CASE

4M41 ENGINE - Crank Shaft and Crank Case 11B-25-5 " E A REAR OIL SEAL / REAR OIL SEAL CASE INSTALLATION (1) Apply a thin coat of engine oil to the lip A of the rear oil seal 11 . Press the rear oil seal all the way into the rear oil seal case 12 in the direction shown. Be sure that the end face B of the rear oil seal is flush with the end face C of rear oil seal case. (2) Apply a 3 mm thick bead of the specified sealant to the fitting surface of the rear oil seal case 12 . 11 B C 12 A Specified sealant: Mitsubishi Genuine Part No. MD970389 or equivalent Caution 1. Apply the sealant evenly, not broken or oversupplied. 2.

Use care not to let the applied sealant slip out of place during installation. " F A FRONT PLATE INSTALLATION Apply a 2 mm thick bead of the specified sealant to the lower crankcase assembly 15 and upper crankcase assembly 24 where indicated in the illustration. 24 Specified sealant: Mitsubishi Genuine Part No. MD970389 or equivalent 15 Caution 1. Apply the sealant evenly, not broken or oversupplied. 2. Use care not to let the applied sealant slip out of place during installation. 3. The bolt 1 that holds the front plate 2 is also used to secure the timing gear case. Attach the front plate with a temporary bolt until the timing gear case is installed. PWEE9409-D E Feb.

2000 Mitsubishi Motors Corporation Added