4M41 ENGINE - Crank Shaft and Crank Case 11B-25-4 A " B A THRUST PLATE INSTALLATION Install the thrust plates 18 and 23 to the crankshaft assembly 19 at No.5 journal only. Install all halves of the thrust plates with the oil groove A oriented outward. 23 A Caution If any oversize thrust plates are to be used, be sure to use an upper thrust plate 23 and lower thrust plate 18 of the same size at one side. However, using the same size upper (or lower) thrust bearings on both sides is not necessary. 19 A 18 A " C A CRANKSHAFT GEAR INSTALLATION (1) Before installing, heat the crankshaft gear 20 to approximately 100 _ C with a piston heater or the like. 20 21 B Caution Use care not to be burned.
(2) Align the notch B in the crankshaft gear 20 with the key 21 of the crankshaft 22 , then install the crankshaft gear 20 onto the crankshaft by tapping on the end face lightly with a plastic hammer. 22 A 14 " D A LOWER CRANKCASE ASSEMBLY INSTALLATION Caution Before installing the lower crankcase assembly 15, check the head of the main cap bolt 14 for punch marks A. The number of punch marks corresponds to the number of times the bolt has been tightened to the plastic area (bolts with two or less punch marks are reusable). If there are three, replace the main cap bolt 14. (1) Apply a 2 mm thick bead of specified sealant to the fitting surface of the upper crankcase assembly 24 as shown.
24 Specified sealant: Mitsubishi Genuine Part No. MD970389 or equivalent Caution 1. Apply sealant evenly, not broken or oversupplied. 2. Use care not to let the applied sealant slip out of place during installation. (2) Apply a thin coat of engine oil to the threaded part and seating surface of each main cap bolt 14 , then tighten the bolts to a torque of 20 ± 2 Nm in the sequence of the numbers shown (17 - 26). (3) After tightening, give the bolts an additional 90 _ turn. (4) Then, give the bolts another 90 _ turn to tighten them completely. (5) Following the main cap bolts 14 , tighten the bolts 13 to the specified torque in the sequence of the numbers shown (1 - 16).
(6) After installing the lower crankcase assembly 15 , check the following: 1) Smooth rotation of crankshaft assembly 19 2) End play of the crankshaft assembly 19 12 13 8 9 1 5 4 16 23 19 17 22 26 25 21 18 20 24 15 10 11 2 3 6 7 14 PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added