Mitsubishi — 26. BALANCE SHAFT BUSH

4M41 ENGINE - Balance Shaft Bush 11B-26-2 (1) Set the tools as shown by passing the remover C , through the balance shaft bush 1 while tilting it as shown. (2) Pull the puller D to bring the washer B into contact with the remover C . Then, turn in the nut G until the plate B is lightly pressed by it. E D B 1 F G C (3) Secure the plate E to the crankcase using bolt J . E H *a H : Dowel pin J : Bolt (M8 x 1.25 mm) J Caution The securing position of the plate E is different between when removing the left-hand and right-hand balance shaft bushes 1. Be sure to secure it in right places. H J E 1 G (4) Tighten the nut G further to remove the balance shaft bush 1 .

INSTALLATION SERVICE POINT " A A BALANCE SHAFT BUSH INSTALLATION Using the special tool, install the balance shaft bushes 1 in the following manner: N M L K Component Parts of Special Tool MH062717 - Balance Shaft Bush Installer K : Installer L : Plate M : Washer N : Nut Caution Apply engine oil to the sliding surfaces of the installer K and plate L. PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added