Mitsubishi — 26. BALANCE SHAFT BUSH

4M41 ENGINE - Balance Shaft Bush 11B-26-3 (1) Fit the balance shaft bush 1 onto the installer K from the non-chamfered side. At this time, align the oil hole with the alignment mark P on the installer. Align the oil hole Q of the left-hand bush with the -line of the installer and the oil hole R of the right-hand bush with the -line. P R P : Alignment mark P (installer) Q : Oil hole (left-hand bush) R : Oil hole (right-hand bush) S : Chamfered side 1 S Q Caution Before installing the balance shaft bush 1 onto the installer K, apply chassis grease to the inside surface of the bush so that the oil hole Q, R does not slip out of position.

E H J *a (2) Secure the plate E to the crankcase using bolt J as shown. Caution 1. Note that the securing position of the plate N is different between the left-hand balance shaft bush and the right-hand bush. 2. Prior to securing the plate E, check that the installer K is correctly positioned with respect to the balance shaft bush 1. H E J (3) Line up the alignment mark P on the installer K and the alignment mark T on the algnment mark plate L . K L T : Alignment mark (plate) T K L T PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added