4M41 ENGINE - Balance Shaft Bush 11B-26-4 K N (4) Screw the nut N onto the installer K up to its alignment mark P to predetermine the press-fitting depth of the balance shaft bush 1 . (5) Strike on the installer K until the nut N positively contacts the washer M to press-fit the balance shaft bush 1 into the crankcase. (6) Check that the oil hole Q , R of the balance shaft bush 1 is in alignment with the oil hole U in the crankcase. U 1 N P U : Oil hole (crankcase) N M *a Q, R INSPECTION 1 BALANCE SHAFT BUSH Measure the clearance between balance shaft bush 1 and balance shaft *b . If the reading exceeds the specified limit, replace the defective part(s). Standard value: 0.06 - 0.11 mm Limit:
0.16 mm 1 *b PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added