4M41 ENGINE - Rocker Cover, Camshaft Holder Assembly and Camshaft 11B-14-2 Removal steps 1. Oil filler cap 2. Bolt 3. Washer " B A 4. Rocker cover assembly " B A 5. Rocker cover gasket 6. Eyebolt 7. Gasket 8. Eyebolt 9. Gasket 10. Fuel leak-off pipe 11. Bolt 12. Upper guide plate A A " " A A 13. Bolt 14. Bolt 15. No.1 camshaft cap 16. No.2 camshaft cap 17. No.3 camshaft cap 18. No.4 camshaft cap 19. No.5 camshaft cap 20. Intake camshaft 21. Exhaust camshaft 22. No.1 camshaft holder 23. No.2 camshaft holder 24. No.3 camshaft holder 25. No.4 camshaft holder 26. No.5 camshaft holder 27. Rocker assembly (short) 28. Lock nut 29. Adjusting screw 30. Rocker (short) 31. Rocker assembly (long) 32.
Lock nut 33. Adjustng screw 34. Rocker (long) 35. Pivot bolt Caution Since the camshaft caps 15 through 19 and camshaft holders 22 through 26 have been machined in pairs, replacement of either one of the pair is not allowed. Also, never alter their original combination. PRE-REMOVAL INSPECTION CAMSHAFT END PLAY Measure the end play, and if the reading deviates from the specified value, replace the defective part. Standard value: 0.10 - 0.18 mm Limit: 0.3 mm *b REMOVAL SERVICE POINT A A " BOLT REMOVAL Caution 1. When removing the bolt 13, be sure to lock the camshaft 20, 21 by holding the hexagonal part A with a proper wrench. Do not use the timing chain *b for the locking. 2.
The bolt 13 is inversely threaded. The arrow mark on its head B indicates its turning direction when tightened. To remove, turn the bolt in the reverse direction. 3. The camshaft sprockets *a and timing chain *b must be meshed in a fixed position. Do not remove the timing chain from the camshaft sprockets unless absolutely necessary. 13 *a B PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added