4M41 ENGINE - Rocker Cover, Camshaft Holder Assembly and Camshaft 11B-14-3 *b INSTALLATION SERVICE POINTS " A A BOLT INSTALLATION Caution The bolt 13 is inversely threaded. The arrow mark on its head B indicates its turning direction when tightened. 13 *a B " B A ROCKER COVER GASKET / ROCKET COVER ASSEMBLY INSTALLATION Before installing the rocker cover 4 , remove all deposites, especially oil in the gasket groove A . 4 Caution Install the rocker cover gasket 5 using care so that it is not distorted. A 5 INSPECTION 1. CAMSHAFT (1) Cam Lobe Lift (Difference between Cam Height and Base Circle Diameter) If the specified service limit is exceeded, replace the camshaft 20 , 21 . A 20, 21 B A :
Cam height B : Base circle diameter Standard value: Intake Front 6.16 mm Rear 6.10 mm Exhaust Front 5.91 mm Rear 6.16 mm Limit: Intake Front 6.11 mm Rear 6.05 mm Exhaust Front 5.86 mm Rear 6.11 mm (2) Bend With the camshaft 20, 21 supported at No.1 journal C and No.5 journal D , measure the bend at No.3 journal E . If the reading exceeds the specified service limit, replace the camshaft 20, 21 . C D 20, 21 Standard value: 0.015 mm or less E Limit: 0.03 mm NOTE The actual shaft bend is a half of what the dial gauge reads when the camshaft 20, 21 is given one turn. PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added