Mitsubishi — 15. INJECTION NOZZLE

4M41 ENGINE - Injection Nozzle 11B-15-2 Caution 1. Fuel is highly flammable. Keep it away from flames and sources of heat. 2. Wipe up spilt fuel completely. It could catch fire. 3. Remove all deposited carbon from the injection nozzle assembly 10 before disassembling, reassembling and adjusting it. Prior to intended disassembly, check the injection nozzle 10 for abnormal injection pressure, abnormal spray pattern and fuel leaks. If it is in order, the disassembly is not needed. 4. Never change the original combination of needle valve 13 and nozzle tip 12 when reassembling each injection nozzle assembly 10. 5. Dust particles can seriously affect the engine performance.

To prevent the ingress of dust, fully cover and close up the opening left after removal of each injection nozzle assembly 10. PRE-REMOVAL INSPECTION Install the nozzle tester A to the injection nozzle assembly 10 and perform the following checks: Caution Prior to proceeding with the checks, bleed air from the fuel injection nozzle by pumping the nozzle tester lever two or three times. A 1. VALVE OPENING PRESSURE CHECK (1) Operate the nozzle tester A lever at 1 to 2 seconds per stroke. Read the pressure when, after a gradual increase, the pointer deflects rapidly. (2) If the reading deviates from the specified standard value, disassemble the fuel injection nozzle, clean and reassemble.

Then, make necessary pressure adjustment using adjusting shims 18, 24 . (3) If the reading still deviates after the adjustment, replace the fuel injection nozzle assembly 10 . 10 2. SPRAY PATTERN CHECK (1) Inject fuel continuously by pumping the nozzle tester A lever quickly (1 to 2 seconds per stroke). B : Even spray from all five injection orifices (Good) C : Even and symmetrical spray (Good) D : Asymmetrical spray (Bad) E : Branched spray (Bad) F : Thin spray (Bad) G : Irregular spray (Bad) C E D F G B (2) Disassemble, clean and recheck the fuel injection nozzle assembly 10 if necessary. If the problem still remains after another check, replace the fuel injection nozzle assembly.

(3) Check that the fuel injection nozzle does not dribble after injection. Caution Do not touch the spray that comes out of the nozzle. PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added