Mitsubishi — 15. INJECTION NOZZLE

4M41 ENGINE - Injection Nozzle 11B-15-3 3. OIL TIGHTNESS CHECK (1) Slowly increase the nozzle internal pressure and maintain it at a pressure 1960 kPa lower than the specified 1st valve opening pressure. In this condition, check that the fuel injection nozzle does not start dribbling within10 seconds. (2) If the dribbling begins in less than 10 seconds, disassemble, clean and recheck the fuel injection nozzle assembly 10 . If the problem still remains after another check, replace the fuel injection nozzle assembly. REMOVAL SERVICE POINTS A A " RETAINING NUT REMOVAL Using the special tool, remove the retaining nut. 10 157944-9520 4ME0510 A 13 Caution 1.

Be sure not to touch the sliding surface A of the needle valve 13 with dirty hands. 2. Be sure not to change the original combination of the needle valve 13 and nozzle tip 12 removed. 4ME0511 10 INSTALLATION SERVICE POINT " A A RETAINING NUT INSTALLATION Using the special tool, install the retaining nut. 157944-9520 4ME0510 Caution 1. Be sure not to touch the sliding surface A of the needle valve 13 with dirty hands. 2. Be sure not to change the original combination of the needle valve 13 and nozzle tip 12 removed. A 13 4ME0511 PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added