Mitsubishi — 15. INJECTION NOZZLE

4M41 ENGINE - Injection Nozzle 11B-15-4 105789-0010 NOZZLE TIP, NEEDLE VALVE CLEANING Wash the needle valve 13 and nozzle tip 12 removed in clean kerosene (cleaning oil) and remove deposited carbon from them in the following manners using the specified special tools. (1) Remove carbon deposited on the tip of the needle valve 13 using the special tool Cleaning Bar. 13 Caution For cleaning, never use a wire brush or any other hard metal tool. (2) Remove carbon deposited in the nozzle hole area of the nozzle tip 12 by turning the special tool Needle Cleaner that runs through the nozzle hole. 105789-0010 12 Cleaning needle diameter:

Less than f 0.21 mm 105789-0010 (3) Clean the seat of the nozzle tip 12 using the special tool Cleaning Scraper. (4) To remove baked carbon, use the Fuso Carbon Remover. 12 NOZZLE TIP, NEEDLE VALVE INSPECTION (1) Wash the needle valve 13 and nozzle tip 12 clean in clean kerosene (cleaning oil) prior to reassembly. (2) Pull out the needle valve 13 to approximately one third of its length, let go of it and see if it slides down by gravity. (Repeat this procedure a few times after turning the needle valve each time.) (3) If the needle valve 13 fails to slide down by itself, wash it again and give it another check. Replace the needle valve 13 and nozzle tip 12 as a set. 13 12 4ME0515 Caution 1.

If a nozzle tip 12 is to be replaced, use a Nozzle Service Kit to replace the needle valve 13, pin 14, lift piece 16 and spacer 15 at the same time. 2. Afterreplacing the nozzle tip12, be sure toreadjust the prelift to bring the valve opening pressure to the specified standard value. Standard value: 0.05 - 0.07 mm PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added