Mitsubishi — 15. INJECTION NOZZLE

4M41 ENGINE - Injection Nozzle 11B-15-5 INJECTION NOZZLE ASSEMBLY ADJUSTMENT While reassembling parts, adjust and check the injection nozzle assembly in the sequence shown below. Caution 1. Before starting adjustments and checks, wash all parts clean in clean kerosene (cleaning oil) to ensure that they are entirely free of dirt and other foreign matters. 2. Never touch the sliding contact surface of the needle valve 13.

Adjusting 1st valve opening pressure Checking full lift of needle valve Checking prelift Adjusting 2nd valve opening pressure 12 17 18 Checking nozzle tip and needle valve 13 15 19 21 22 23 ADJUSTING 1ST VALVE OPENING PRESSURE (1) Fit parts 12 through 24 to the nozzle holder 25 . 24 25 20 14 16 4ME0516 16 (2) Fit the lift piece 16 in the illustrated direction. 16 20 4ME0517 (3) Fit the special tool Gasket onto the nozzle tip 12 , then secure the nozzle tip to the nozzle holder 25 with the special tool Retaining Nut (for adjustment). Turn the special tool Retaining Nut (for adjustment) handtight, then tighten it to the specified torque (34 ± 5 Nm).

157892-3200 12 157892-5100 25 4ME0518 PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added