Mitsubishi — 15. INJECTION NOZZLE

4M41 ENGINE - Injection Nozzle 11B-15-9 (3) Note the value indicated by the pressure gauge H the moment the dial gauge indicates the specified amount of needle valve lift (normally prelift E + 0.05 mm). D D : Needle valve full lift E + 0.05 Standard value: 22.6 - 23.6 MPa Needle valve lift (mm) 1st valve open- ing pressure Pipe pressure (MPa) 2nd valve opening pressure E 0 34.3 - 44.1 E 157954-3801 A H (4) If the dial gauge reading deviates from the specified limits of standard value, disassemble the nozzle holder 25 and make pressure adjustment by changing the existing shim 18 for a shim with appropriate thickness.

Thicknesses of available 2nd valve opening pressure adjusting shims (outside diameter: f 7.2 mm): 0.10, 0.20, 0.30, 0.40, 0.50, 0.51, 0.52, 0.53, 0.54, 0.55, 0.56, 0.57, 0.58, 0.59 mm 18 Caution Adjusting the 1st valve opening pressure changes the 2nd valve opening pressure. After the lst valve opening pressure is altered, therefore, be sure to check and readjust the 2nd valve opening pressure. 25 157954-3801 CHECKING INJECTION NOZZLE ASSEMBLY Upon completion of all necessary adjustments, perform a final check on the injection nozzle assembly by the following procedure. 157892-1000 157892-4400 (1) Remove the special tools Dial Gauge, Nut and Holder.

4ME0533 157892-5120 (2) Remove the special tools Retaining Nut (for adjustment) and Gasket. (3) Check that the pin 14 is secured in position. Install the regular retaining nut 11 handtight. then tighten it to the specified torque. (4) Attach the nozzle holder 25 to the nozzle tester B . Using the nozzle tester B , check the 1st valve opening pressure, spray form and seat oiltightness. Check that all parts are leak-free at the same time. 157892-3200 4ME0534 PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added