4M41 ENGINE - Cylinder Head and Valve Mechanism 11B-16-2 Apply engine oil to all moving parts before installation. 17 18 19 20 21 26 22 25 29 47 ± 5 Nm 30 23 24 27 31 28 32 Removal steps 17. Valve cap A B " " E A 18. Valve cotter 19. Valve spring retainer " D A 20. Valve spring 21. Valve spring seat " C A 22. Valve stem seal 23. Exhaust valve 24. Intake valve A C " " B A 25. Exhaust valve guide A C " " B A 26. Intake valve guide A D " " A A 27. Exhaust valve seat A D " " A A 28. Intake valve seat 29. Sealing cap ( f 35 mm) 30. Stud 31. Water joint 32. Cylinder head Caution 1. The cylinder head bolt 12, 13 is tightened to the plastic area.
If the bolt shows the evidence of having been tightened three times, replace it with a new ones. 2. The timing chain slips out of place if the camshaft sprocket is removed from it. If the chain comes off, remove the timing gear case assembly and put the chain back in position. 3. Replace the valve stem seal 22 with a new one once the exhaust valve 23 or intake valve 24 is removed. PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added