4M41 ENGINE - Cylinder Head and Valve Mechanism 11B-16-4 MD998772 A B " VALVE COTTER REMOVAL 1> Using the special tools, remove the valve cotters 18 as follows. MD998784 18 Component parts of special tool MD998772 Valve Spring Compressor A : Wing bolt B : Retainer C : Handle D : Nut E : Bolt F : Slotted screw G : Stay H : Lock nut J : Tension spring K : Mobile nut L : Washer M : Snap ring N : Retainer holder A B C D E G F J K L M N H MD998784 P (1) Install the special tools on the cylinder head 32 as shown in the illustration. P : Bolt (M8 x 12.5 mm) 32 MD998772 (2) Install the special tool MD998772 on the special tools MD998784. MD998784 Q : Washer R :
Nut (M6 x 1 mm) Q R (3) Move the retainer B and mobile nut K into a position where the retainer holder N presses the valve spring retainer 19 from right above, then secure them with the wing bolt A . Use the nuts D to adjust the vertical position of the stay G . G K A B 19 D NOTE Set the stay G level. N PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added