4M41 ENGINE - Cylinder Head and Valve Mechanism 11B-16-9 A B C D " F A CYLINDER HEAD GASKET INSTALLATION The cylinder head gasket 16 is a part that needs to be selected for use. Select the appropriate gasket in the following manner. (1) When replacing the cylinder head gasket alone-Identify; the crankcase assembly *d by the crankcase identification mark , , or stamped on its top surface and select a gasket of the size corresponding to the mark. (2) When replacing the piston and connecting rod as well; 1) Measure the piston protrusion from each cylinder. 2) Select the gasket 16 corresponding in thickness to the largest of the measured piston protrusions.
15 NOTE The gasket varies in type according to the number of notches in its notched end E . 16 - *d E *c Unit: mm " G A CYLINDER HEAD ASSEMBLY INSTALLATION 12, 13 G Caution Before installing the cylinder head bolt 12, 13, check the number of punch marks D on its head. (The bolt is reusable if it is two or less.) The number of punch marks corresponds to that of times the bolt has been tightened to the plastic area. If the bolt has three punch marks, replace it. PWEE9409-D E Feb.
2000 Mitsubishi Motors Corporation Added Piston projection Cylinder head gasket Maximum piston projection Crankcase identification mark Type by size Tightened thickness 0.03 - 0.11 A A (1 notch) 0.67 - 0.73 -0.05 - 0.03 B B (2 notches) 0.72 - 0.78 -0.13 - -0.05 C C (3 notches) 0.77 - 0.83 -0.23 - -0.15 D D (4 notches) 0.82 - 0.88