Mitsubishi — 16. CYLINDER HEAD AND VALVE MECHANISM

4M41 ENGINE - Cylinder Head and Valve Mechanism 11B-16-10 H *d (1) Apply a coat of specified sealant to the upper surface H of the front plate *c that joins the cylinder head gasket 16 . Specified sealant: ThreeBond 1211 or equivalent H (2) Within 3 minutes after the sealant application, install the cylinder head assembly 15 to the crankcase assembly *d together with the cylinder head gasket 16 . *c *e Caution 1. Check to ensure that the surface H is clean and free of oil and other foreign matters before sealant application. 2. During installation of the cylinder head assembly, use care that the sealant is kept in place. 3.

Do not start the engine for at least 1 hour after the cylinder head assembly is installed. 4. Whenever the cylinder head bolt 11, 12, 13 is loosened or removed after the cylinder head assembly has been installed, always apply a fresh coat of specified sealant. 15 10 11 6 7 3 1 14 18 (3) Tighten the M12 cylinder head bolts 12 and 13 (1 through 18) at M10 bolts 11 in the following manner. 1) Fit the washer 14 onto the cylinder head bolt 12 , 13 , with its shear-droop side J facing in the direction shown.

2) Apply a thin coat of engine oil to the threaded part and seating surface of each cylinder head bolt 12 , 13 , then tighten the bolts to a torque of 98 ± 10 Nm in the sequence of the numbers shown. 3) Loosen the tightened bolts in the reverse order of the numbers shown and retighten them to a torque of 49 ± 5 Nm in the order of the numbers shown. 4) After tightening, give the bolts an additional 90 degree turn in the sequence of the numbers shown. 5) Then, give the bolts another 90 degree turn to tighten them completely. 6) After tightening the cylinder head bolt 12 , 13 , tighten the bolt 11 to the specified torque.

17 12 13 8 9 5 2 4 16 J 11 12, 13 14 Caution The cylinder head bolt 12, 13 has been tightened up to the plastic area by the above procedure. Once tightened completely, do not attempt to retighten the bolt. " H A GASKET / TENSIONER INSTALLATION (1) Fit the gasket 10 to the cylinder head assembly 15 in the direction shown in the illustration. E E : Sealant coated surface 10 15 9 PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added