4M41 ENGINE - Cylinder Head and Valve Mechanism 11B-16-11 B C (2) Turn the cam A of the tensioner 9 to thrust the plunger B in and lock the plunger with the hook C . Then, install the tensioner in that state. (3) Crank the engine in the normal direction (clockwise). *b A Caution 1. If the tensioner 9 is installed without thrusting the plunger B in, the timing chain *b may be damaged by excessive tension. 2. The tensioner 9 stretches the timing chain *b to optimum tension by means of the internal ratchet mechanism.
If the engine is cranked counter- clockwise (as viewed from the front) after the ten- sioner 9 is installed, an excessive thrust is exerted to the plunger B and the cam A may be damaged as a result. Should the engine be cranked counter- clockwise, remove the tensioner and re-install it in the sequence described above. 9 D NOTE If the engine is cranked in the normal direction (clockwise) after the tensioner has been installed, the hook C will be released automatically, the timing chain being adjusted to optimum tension by means of the internal ratchet mechanism. INSPECTION 1.
INTAKE AND EXHAUST VALVES (1) Checking Stem for Wear Replace the valve 23 , 24 if the diameter is below the specified service limit or uneven wear is recognized. Standard value: Intake 6.560 - 6.575 mm Exhaust 6.53 - 6.55 mm 23, 24 Limit: 6.45 mm Caution If the valve 23, 24 is new, be sure to lap it and the valve seat 27, 28 for proper seating. (2) Valve Seat Angle and Valve Margin Correct or replace the valve 23 , 24 if the specified service limit is exceeded. 23, 24 Standard value: Valve seat angle 45 _ ± Valve margine 1.0 mm Limit: Valve margine 0.8 mm A B A : Valve seat angle B : Valve margin PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added