Mitsubishi — 16. CYLINDER HEAD AND VALVE MECHANISM

4M41 ENGINE - Cylinder Head and Valve Mechanism 11B-16-12 2. VALVE SEAT (1) Valve Seat Width Replace the valve seat 27 , 28 if the specified service limit is exceeded. 23, 24 27, 28 A A : Valve seat width Standard value: 1.8 - 2.2 mm Limit: 2.8 mm Caution When the valve seat 27, 28 has been corrected or replaced, lap it and the valve 23, 24 for proper seating. (2) Valve Sinkage from Cylinder Head Bottom If the specified service limit is exceeded, correct or replace the defective part. 23, 24 27, 28 B : Valve sinkage Standard value: 0.05 - 0.55 mm Limit: 0.8 mm B 3. VALVE AND VALVE GUIDE If the clearance exceeds the specified service limit,replace the defective part.

23, 24 25, 26 Standard value: Intake 0.02 - 0.06 mm Exhaust 0.05 - 0.09 mm Limit: Intake 0.10 mm Exhaust 0.15 mm 4. VALVE AND VALVE SEAT (1) Apply an even coat of minium to the valve seating surface A of the valve seat 27 , 28 . (2) Strike the valve 23 , 24 against the valve seat 27 , 28 once while taking care that the valve is not rotated. A B 23, 24 B : Valve Lapper Caution Before proceeding with the contact check, examine the valve 23, 24 and valve guide 27, 28 in detail to see if they are in normal condition. (3) Determine the valve seating condition from minium pattern printed on the valve 23 , 24 . If any abnormal contact is found, take the following corrective action.

PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added Condition Corrective action Minor defect Lap valve for better seating. Major defect Correct or replace valve and valve seat.