Mitsubishi — 16. CYLINDER HEAD AND VALVE MECHANISM

4M41 ENGINE - Cylinder Head and Valve Mechanism 11B-16-13 5. CYLINDER HEAD ASSEMBLY Measure the distortion of the bottom surface of the cylinder head 31 . If the measured value exceeds the limit, replace the cylinder head. Standard value: 0.05 mm or less Limit: 0.2 mm CORRECTION 1. INTAKE VALVE AND EXHAUST VALVE Caution 1. The grinding should be minimum. 2. If the valve margin deviates from the specified service limit after grinding, replace the valve 23, 24. 3. After grinding, lap the valve 23, 24 and valve seat 27, 28 for proper seating. E D 2. VALVE SEAT (1) Grind the valve seat 27 , 28 using a valve seat cutter or a valve seat grinder.

(2) Polish the ground surface lightly using a #400 sandpaper held between the cutter and valve seat. (3) Correct the seat width C of the valve 23 , 24 to the specified value using a 15 _ or 75 _ cutter. 23, 24 27, 28 C D : Valve seat angle Standard value: 45 _ ± Caution 1. Be sure that the sinkage E of the valve 16, 17 does not exceed the specified service limit as a result of the correction. 2. After the correction, lap the valve 23, 24 and valve seat 27, 28 for proper seating. Limit: 0.8 mm 3. VALVE AND VALVE SEAT Lap the valve and valve seat as follows: (1) Apply a thin coat of lapping compound evenly to the valve seating surface A of the valve seat 27 , 28 . 23, 24 Caution 1.

Keep the stem C of the valve 23, 24 free from the lapping compound. 2. Use an intermediate-mesh compound (120 - 150 meshes) first, then a fine-mesh compound (over 200 meshes). 3. To achieve even application of the lapping compound, a mix with a small quantity of engine oil is recommended. C A PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added