Mitsubishi — 19. TIMING GEAR AND BALANCE SHAFT

4M41 ENGINE - Timing Gear and Balance Shaft 11B-19-5 A 16 " F A BALANCE SHAFT RH ASSEMBLY INSTALLATION (1) Assemble the parts shown in the illustration to the balance shaft RH 19. Be sure to install the washer 14 and thrust spacer 16 in the direction shown in the illustration, and install the balance shaft gear RH 15 with its mating mark aligned with the mating mark 6 on the oil pump gear *d . 14 15 19 *d A : Shear droop side 12 *e (2) Insert the completed balance shaft RH assembly 12 into the crankcase assembly while aligning the mating marks 5 on the oil pump gear *d and the crankshaft gear *c , and set the shaft assembly in position with the dowel pin on the crankcase assembly *a.

*d Caution Insert the balance shaft RH assembly using care not to damage the inner surface of the balance shaft bush in the crankcase. *c *a (3) After the timing gears are installed in position, check that all the rotary parts smoothly rotate. D F G " G A TIMING CHAIN INSTALLATION (1) Hold the camshaft sprocket 2 using the special tool. E Component Parts of Special Tool MH063490 - Cam Sprocket Holder Kit A : Nut B : Washer C : Spacer D : Adjusting plate E : Nut G : Bolt A B 2 A B 2 C (2) Check that the match mark 1 on the idler gear and sprocket assembly 42 is in alignment with that on the crankshaft gear *c .

(3) Align the match mark on the idler gear and sprocket assembly 42 with the mark link plate H of the timing chain 3 . J J 2 3 Caution The timing chain 3 has the match mark provided at two places: one bright white link plate H at one place and a pair of bright white link plates J at the other. (4) Place the timing chain 3 around the camshaft sprockets 2 while aligning the timing mark on the camshaft sprockets with the mark link plate J on the timing chain. (5) After installing the timing chain 3 , attach the idler washer 41 with the front mark F facing outward. *c 39 41 42 H PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added