4M41 ENGINE - Timing Gear and Balance Shaft 11B-19-6 D L E INSPECTION 1. TIMING CHAIN (1) Aligning the stamped lines L on the adjusting plate D and nut E , set the camshaft sprocket 2 in position. (2) Push the tension lever 5 by hand to take up the slack of the timing chain 3 . Measure the minimum clearance K between the chain spans facing each other. If the reading deviates from the specified limit, replace the timing chain. 2 3 K 5 Standard value: 16.5 mm Limit: 9 mm A 5 2. TENSION LEVER AND TENSION LEVER SHAFT (1) Replace the tensioner lever 5 if it shows any cracks or flakes on the surface A that makes sliding contact with the timing chain and the tensioner contact surface B .
B (2) If the tensioner lever 5 to tension lever shaft 6 clearance exceeds the specified limit, replace the defective part. 5 6 Standard value: 0.06 - 0.18 mm Limit: 0.3 mm 3. GUIDE PLATE Replace the guide plate 10 if it shows any cracks or flakes on the surface A that makes sliding contact with the timing chain. A 10 PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added