Mitsubishi — 23. PISTON AND CONNECTING ROD

4M41 ENGINE - Piston and Connecting Rod 11B-23-8 " F A CONNECTING ROD BEARING INSTALLATION The connecting rod bearing 2 , 4 to be used must have an appropriate thickness that matches the big end I.D. of the connecting rod and the pin O.D. of the crankshaft assembly. There are two methods available for selecting an appropriate bearing. *a by measurement> (1) Measure the big end I.D. of the connecting rod (with connecting rod bearing 2 , 4 removed) and the pin O.D. of the crankshaft assembly. A A : Measuring point Connecting rod: 1 point in vertical direction Crankshaft: 1 point in any direction A Caution Before measuring the big end O.D.

of the connecting rod, tighten the nut B to a torque of 49 ± 5 Nm. B 2 (2) Select connecting rod bearing shells 2 , 4 having the thickness that matches the respective measured values from the table below. Install the selected connecting rod bearing shells with their lug C fitted in the mating groove of the connecting rod. C D : Location of connecting rod bearing identification color (side) 4 E C Caution The upper connecting rod bearing shell 4 has an oil hole E, while the lower connecting rod bearing shell 2 has no oil hole. Be careful not to install them in wrong place. D PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added Crankshaft pin O.D. Connecting rod big end I.D.

Compatible connecting rod bearing identification color (Figures in brack- ets are sheet thicknesses) 53.980 - 53.988 58.010 - 58.019 mm None (1.992 - 1.996 mm) 58.000 - 58.010 mm Blue (1.988 - 1.992 mm) 53.971 - 53.980 58.010 - 58.019 mm Yellow (1.996 - 2.000 mm) 58.000 - 58.010 mm None (1.992 - 1.996 mm)