Mitsubishi — 23. PISTON AND CONNECTING ROD

4M41 ENGINE - Piston and Connecting Rod 11B-23-7 ¬ (4) Using the special tool, install the piston and connecting rod assembly in position, with the front mark ¬ on the piston crown facing toward the engine front F . F MH063484 1 3 (5) Press the piston down. Apply a thin coat of engine oil to the threaded part of the connecting rod bolt, then install the connecting rod cap 3 while aligning the lugs H of the upper connecting rod bearing shell 4 and lower connecting rod bearing shell 2 . (6) Tighten the nuts 1 alternately in the following manner. 1) Tighten the nut 1 to a torque of 29 ± 3 Nm. 2) Tighten further to a torque of 49 ± 5 Nm. 3) Give a 45 _ ± 5 _ turn.

4) Give another 45 _ ± 5 _ turn to complete the tightening. 2 H 4 Caution The nut is tightened to a point where the bolt is plastically deformed. Do not tighten it any more than the final turn. (7) After the connecting rod cap 3 is secured, check the following. 1) Connecting rod end play 2) Piston protrusion PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added