4M41 ENGINE - Piston and Connecting Rod 11B-23-6 (2) Apply a thin coat of engine oil to the piston pin 10 prior to insertion. Assemble the connecting rod 12 and piston 11 facing in the directions shown. ¬ : Connecting rod identification mark ¬ : Front mark NOTE To make the piston pin 10 easy to install, warm the piston 11 over an appropriate heater or in hot water if necessary. 10 11 Caution After inserting the piston pin 10, check to ensure that the piston moves smoothly with little play. 9 12 " D A PISTON RING INSTALLATION (1) Install the oil ring 8 onto the piston 11 with its end gap positioned at A and the abutting end of the expander spring at B as shown.
(2) Install the compression rings 6 , 7 onto the piston 11 , with their manufacturer’s mark C (stamped near the end gap) facing upward and their end gap D , E positioned as shown. B D ¬ C E 11 6, 7 A D : End gap of 1st compression ring E : End gap of 2nd compression ring ¬ : Front mark " E A PISTON AND CONNECTING ROD ASSEMBLY INSTALLATION 5 A Caution Before installing the piston and connecting rod assembly 5, check the head of the nut 1 for punch marks. The number of punch marks corresponds to the number of times the mating connecting rod bolt has been tightened to the plastic area (bolts with two punch marks or less are reusable).
If there are three (the evidence of having been tightened 3 times), replace both the nut 1 and the connecting rod bolt B. (1) Check that the end gaps of the piston rings C are in position. (2) Check that the size marks D on the pistons are the same as the respective marks on the upper crankcase. (3) Sheathe the connecting rod bolt B with a vinyl hose E so as not to damage the cylinder inside surface of the upper crankcase *b and the pin of the crankshaft assembly *a . 14 1 *b D C 5 B E *a PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added