4M41 ENGINE - Piston and Connecting Rod 11B-23-5 " B A CONNECTING ROD BUSH INSTALLATION Use the special tool to install the connecting rod bush 13 . H J Component Parts of Special Tool MH062574 - Connecting Rod Bush Puller Kit A : Collar B : Collar C : Puller D : Base E : Bracket F : Plate G : Nut C 15 13 B 13 (1) Apply a thin coat of engine oil to the outside surface of the connecting rod bush 13 and the bush fitting hole in the connecting rod 15 . (2) Set the collar B , connecting rod bush 13 and collar A on the puller C as shown and secure them with the nut G .
(3) Aligning the oil holes J , press-fit the connecting rod bush 13 into the connecting rod 15 slowly under a press ram load H of approximately 49,035 N. (4) After press-fitting, ream the connecting rod bush 13 for the specified push-to-piston pin clearance. A G Standard value: 0.03 - 0.05 mm Limit: 0.1 mm Caution After reaming, insert the piston pin 10 into the connecting rod bush 13 to ensure that it smoothly moves with little play. H " C A PISTON / PISTON PIN / CONNECTING ROD ASSEMBLY INSTALLATION (1) Use a piston 11 having the same size mark , , or as that stamped beside each cylinder on the upper crankcase. (The marks are found in the order of the cylinders No.
1, 2, 3 and 4 starting from the engine front G .) G H : Location of stamped size mark Caution A mismatch of size marks can result in the piston 11 being seized while in motion. PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added