4M41 ENGINE - Piston and Connecting Rod 11B-23-4 A C " PISTON PIN / PISTON / CONNECTING ROD ASSEMBLY REMOVAL Remove the piston pin 10 using an appropriate push-out bar D as shown. 9 10 D 11 NOTE To make the piston pin 10 easy to remove, warm the piston 11 over an appropriate heater or in hot water if necessary. 12 A D " CONNECTING ROD BUSH REMOVAL Use the special tool to remove the connecting rod bush 13 . MH062574 Component Parts of Special Tool MH062574 - Connecting Rod Bush Puller Kit A : Collar B : Collar C : Puller D : Base E : Bracket F : Plate G : Nut C H 1. Secure the connecting rod 15 to the base D with the bracket E and plate F . 2.
Attach the collar A onto the puller C as shown, and remove the connecting rod bush 13 slowly under a press ram load H of approximately 49,035 N. A F 15 13 E D INSTALLATION SERVICE POINTS " A A CONNECTING ROD BOLT INSTALLATION (1) Check that the bolt hole A in the connecting rod 15 is free of damage, burrs, etc. (2) Apply a thin coat of engine oil to the knurled portion B of the connecting bolt 14 . Then, fit it in the connecting rod with the notch C in the head inward under a press ram load of less than 4,903 N. 15 14 C B A C : Notch in bolt head PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added