4M41 ENGINE - Piston and Connecting Rod 11B-23-10 (2) Connecting Rod Bearing-to-Crankshaft Clearance (Oil clearance) 1) Fit the lower connecting rod bearing shell 2 and upper connecting rod bearing shell 4 in the connecting rod cap 3 and the piston and connecting rod assembly 5 , respectively. Tighten the nuts 1 to a torque of 49 ± 5 Nm. 2) Measure the I.D. of the connecting rod bearing 2 , 4 and the pin O. D. at A of the crankshaft *a . If the readings exceed the specified limit, replace the defective part(s). 5 4 2 3 1 *a Standard value: 0.03 - 0.05 mm Limit: 0.1 mm A 3) When the connecting rod bearing 2 , 4 is replaced with an undersize bearing, adjust the pin O.D.
of the crankshaft *a to the specified undersize dimension. F 2. PISTON RING (1) Piston Ring End Gap 1) Place the piston ring 6 , 7 , 8 level in the cylinder F of the upper crankcase using the crown of the piston 11 . 2) Holding the piston ring 6 , 7 , 8 in place, measure its end gap with a feeler gauge G . If the reading exceeds the specified limit, replace the piston ring. 11 G 6, 7, 8 Standard value: 1st compression ring 0.3 - 0.45 mm 2nd compression ring 0.4 - 0.55 mm Oil ring 0.3 - 0.5 mm Limit: 0.8 mm Caution 1. To place the piston ring 6, 7, 8 level in the cylinder F, be sure to use the piston 11. 2.
Place the piston ring 6, 7, 8 at the lower part of the cylinder F where the cylinder wall wears less than elsewhere. 3. When it becomes necessary to replace any of the piston rings 6, 7 and 8, replace all of them as a set. PWEE9409-D E Feb. 2000 Mitsubishi Motors Corporation Added